What are the specific reasons why shot blasting equipment always experiences shot leakage? How can the shot blasting amount of the shot blasting equipment be adjusted? In addition, there are other questions about shot blasting equipment that will be given specific examples below, along with specific answers, so that everyone can learn * and thoroughly, so as to have a good grasp.

1. Shot blasting equipment always experiences shot leakage. What are the specific reasons for this?

For the phenomenon of shot leakage in shot blasting equipment, if analyzed and summarized in terms of specific reasons, the main ones are:

Reason 1: Due to the shape of the workpiece, a portion of the steel shot is taken out. Alternatively, when the shot blasting is completed and the workpiece is hung down, some steel shots may fall to the ground or remain on the workpiece. If not cleaned in a timely manner, they may accumulate more and may be carried to the next process.

Reason 2: After long-term use, the sealing performance of the shot blasting equipment decreases, resulting in a deterioration of the sealing effect. So, in certain areas, steel balls may appear.

Reason three: The top of the shot blasting chamber in the shot blasting equipment is not completely sealed. So, when the steel shot hits the surface of the workpiece, due to the rebound effect, it may fly out, causing shot leakage.

How can the shot blasting amount of the shot blasting equipment be adjusted?

By adjusting the shot blasting amount of the shot blasting equipment, the number of shot blasters can be turned on while checking whether the amount of steel shot is sufficient. If there are corresponding valves on the equipment, then flow adjustment can be performed. If there are control buttons, it is also possible.

3. Which shot blasting equipment is suitable for use in wind turbine towers?

In wind turbine towers, hanging shot blasting equipment is generally used for cleaning work, as it can achieve good cleaning results. And it is transported by a suspension chain, with one end in and one end out. During the cleaning process, it is usually done by closing the door in the shot blasting room to avoid problems.